Assuming you have your SBC already set up with your IP-PBX, with one or more clients configured and running calls between them, the following guide highlights specific configuration for use with your Telnyx trunk. We recommend reviewing the entire AudioCodes SBC guide here for full setup.

Instructions for Configuring an AudioCodes SBC

Video Walk-through

Coming soon! This walk-through will demonstrate setting up an IP based connection with AudioCodes SBC. We'll also show you how to assign this connection to a newly purchased DID which will allow you to receive inbound calls. Then we'll walk you through how to assign the connection to an outbound profile such that you can make outbound calls!


For step by step instructions on each of the requirements on the Telnyx Mission Control Portal, please follow this guide. Once you've configured your Telnyx account, you can now proceed to setup AudioCodes SBC following the guide below.


You are now all set on the Mission Control Portal side and are ready to configure your Telnyx trunk within your AudioCodes SBC system.

Define your IP Group:

[ IPGroup ]
IPGroup_Description: Telnyx
[ \IPGroup ]

Define your SIP Proxy:

[ ProxyIp ] 
FORMAT ProxyIp_Index = ProxyIp_IpAddress, ProxyIp_TransportType, ProxyIp_ProxySetId;
ProxyIp 1 = "", 0, 1;
ProxyIp 2 = "", 0, 1;
[ \ProxyIp ]

Define Coders:

[ CodersGroup0 ]
CodersGroup0_Name: g711ulaw64k
CodersGroup0_pTime: 20
CodersGroup0_PayloadType: 0
[ \CodersGroup0 ]

Depending on your requirements, you may need to set more configurations such as IP profiles and Routing.


Review our getting started with guide to make sure your Telnyx Mission Control Portal account is setup correctly!

Check out AudioCodes SBC full guide for detailed instructions

Can't find what you're looking for?

Our knowledge base is currently undergoing a makeover which will include more up to date videos to match our ever growing platform!

Can't find what you're looking for? Click the chat bubble at your lower right hand corner and start a chat!

Did this answer your question?