Zoiper Communicator IAX & SIP softphone is a free converged Internet communication tool combining high-quality voice and video calls, fax, instant messaging and presence through a contact-centric intuitive interface. The Zoiper Service is embedded in your Zoiper Communicator and assures free advanced Zoiper-to-Zoiper communication.

Note: You can choose not to use the Zoiper service with Zoiper Communicator. Simply choose "I don't want to use this service" from the interface on initial startup. You can also just not log into the service on startup as well.

Note: Zoiper does not advertise or offer Zoiper Communicator at this time, however it is still available for use via the link above.

Additional Resources:


Instructions for Configuring Zoiper Communicator

In this activity you will:

  1. Add Telnyx as your SIP provider and create a trunk

Pre-requisites

Video Walkthrough

Setting up your Telnyx SIP portal account so you can make and receive calls:

Note: We are trying to find a Zoiper Communicator video and have it available soon! Check back frequently as we are updating our documentation.

1. Add Telnyx as your SIP provider and create a trunk

In this section, you'll configure your first SIP trunk on your Zoiper Communicator softphone.

  1. Start Zoiper Communicator and select Settings.

  2. Select Create New Account.

  3. Enter a name for your new account and click OK.

  4. On the SIP Account Options page, provide the following information:

    1. Domain: sip.telnyx.com

    2. Username: Your main Telnyx account or sub-account username

    3. Password: Your main Telnyx account or sub-account password

    4. Caller ID Name: Choose whatever name you prefer. Note the following caller ID naming conventions:

      1. Caller ID Name should be in capital letters. This will appears more clearly/visible on some devices.

      2. You must NOT use any special characters, as they will not be displayed. Spaces are allowed.

      3. Some of regular Canadian providers will not show more than 15 characters. We suggest shrinking or adapt your caller ID.

  5. Click OK to complete the setup.

That's it! You've finished configuring your Zoiper Communicator softphone, and can now start testing calls!


Additional Resources

Review our getting started with guide to make sure your Telnyx Mission Control Portal account is setup correctly!

Additionally, check out:


Can't find what you're looking for? Click the chat bubble at your lower right hand corner and start a chat!

Did this answer your question?