Configuring  a VOIP Trunk User/Pass :

  1. Login into the UCM6202 web GUI, access to PBX.
  2. Click on Extension / Trunk. This will give you a drop down list. 
  3. Click on “VoIP Trunks” to create a new SIP trunk.
  4. In The VoIP Trunks page, click on option “+ Create New SIP Trunk”.

5) Select the Type as "Register SIP Trunk".

Provider name : Telnyx_LLC

Host Name : 192.76.120.10 or sip.telnyx.com

Transport : It depends on your requirement. (Normally it would be UDP)

Username : Username used for the registration. Should be the same as the Connection name on Telnyx portal → Connection tab.

Password : Password used for the registration. Should be the same as the Connection password on Telnyx portal → Connection tab.

After entering the above details, Click on save. This will only save the trunk configurations and its not going to send the registration packet from your end. 

6) After saving the configuration, please click on the trunk which you have saved to edit few settings before completing the registration.

→ Click on Advanced Settings tab. 

Codec Preference : G.722, PCMU, PCMA, GSM, G.729. 

DTMF Mode : RFC2833

The Maximum Number of Call Lines : <it depends on your requirement>

After entering all the required details, Please click on “save” and “Apply Changes”.

When you click on Apply changes, it will send the registration packets to portal connection. 

Now we need to setInbound and Outbound Rules.

7) Inbound Routes :

Click on Extension / Trunk →Click on “Inbound Routes”to create a new SIP trunk →In the “Inbound Routes”,click on option “+ Add”to create a new inbound rule.

Details on thisscreen : 

Trunks : <Select the Sip trunk which you have created in VoIP Trunks Page>

Pattern : You need to enter the number in different format which you have purchased on Telnyx Portal. 

For example : _+17803063450

                      _17803063450

                      _7803063450

Default Mode →Default Destination : Extension (and select the extension).

After entering all the required details, Please click on “save” and “Apply Changes”.

8) Outbound Rules :

Click on Extension / Trunk →Click on “Inbound Routes”to create a new SIP trunk →In the“Outbound Routes”, click on option “+ Add”to create a new outbound rule.

Detailson this screen : 

Calling Rule Name : Outbound_Telnyx

Pattern: _+1NXXNXXXXXX

              _1NXXNXXXXXX

              _NXXNXXXXXX

Use Trunk : Enter the name of the Trunk which you have created. 

Afterentering all the required details, Please click on “save” and“Apply Changes”.

Youshould be all set. 

Goahead and make some test calls!

Be sure to test inbound and outbound calls to the number you purchased via Mission Control

Did this answer your question?